part numbers as I go

Discussions of the drivetrain, including tracks transmissions, sprockets, and any non engine powertrain issues.
Post Reply
ken from worcester
Posts: 96
Joined: Sun Mar 25, 2012 12:18 pm

part numbers as I go

Post by ken from worcester »

there is not a lot of information on the web for replacment parts so I am going to start listing the parts that I am using please list any parts that you find or parts that can be modified

rear bearing for the winch pto new departure # 88505 easy to get on ebay $25 with shipping

track roller bearings the original bearings were new departure 3205 but a direct replacment is now 6205z these are sealed on both sides I removed the innner seal these were all over ebay I paid $70 plus shipping fo 30
thanx ken
ken from worcester
Posts: 96
Joined: Sun Mar 25, 2012 12:18 pm

Re: part numbers as I go

Post by ken from worcester »

this is from a former owner of a ca1 I figured i would pass it on
thanx ken
Just a bit of advice. Use only Mineral oil (available from farm stores) in the transmission of the CA-1. ---see manual---I suggest draining and putting new Mineral Oil in just in case someone misguided didn’t use it. The clutches will only work properly with mineral oil –not differential lube or any other kind of oil or grease.
admin
Site Admin
Posts: 37
Joined: Thu Jul 21, 2011 12:51 pm
Location: Tilton, NH USA

Re: part numbers as I go

Post by admin »

Thanks for the TIp

I believe he is talking about Gear OIl.

GL1 can be readily obtained from NAPA or Tractor Supply.

Bill
ken from worcester
Posts: 96
Joined: Sun Mar 25, 2012 12:18 pm

Re: part numbers as I go

Post by ken from worcester »

HI bill I am not sure on the oil he is talking abought he could be wrong
thanx ken
Post Reply