Clarkair hydraulic jack seals
Clarkair hydraulic jack seals
Does anyone know where I can get some new seals for the hydraulic jacks please? Any help appreciated.
-
ken from worcester
- Posts: 96
- Joined: Sun Mar 25, 2012 12:18 pm
Re: Clarkair hydraulic jack seals
Hi welcome to the forum the seals in the pistons are not avalible the piston seals are made from a fabric leather or something I used a off the shelf seal that fit in the groove I used them in the 2 outer grooves leaving the the center seal in
the shaft seals are also not a standard size I think they are 1 1/4 x 2 1/8 cheveron seals I took the closest size with the corect inner and turned the od to fit in the bore on my lathe it was a pain but it worked no leaks
how are your rods and caps mine were junk I got chrome 1 1/4 rod stock from a local shop and cut the ends off my rods and welded them on to the new rods that is after turning new theads on the piston ends
I also put bushings in my caps they had 1/8 of slop in them
I will find the seal numberd and post them thanx ken
the shaft seals are also not a standard size I think they are 1 1/4 x 2 1/8 cheveron seals I took the closest size with the corect inner and turned the od to fit in the bore on my lathe it was a pain but it worked no leaks
how are your rods and caps mine were junk I got chrome 1 1/4 rod stock from a local shop and cut the ends off my rods and welded them on to the new rods that is after turning new theads on the piston ends
I also put bushings in my caps they had 1/8 of slop in them
I will find the seal numberd and post them thanx ken
-
ken from worcester
- Posts: 96
- Joined: Sun Mar 25, 2012 12:18 pm